Steering lock for all Airhead Boxers
With two keys, fresh grooved pin, washer washer, new round cover and brand new spring
By the way: the removal of the old lock cylinder is not so difficult - see instructions
Outer diameter 12 mm, spigot length 18 mm, spigot width 7 mm, total length 44 mm
Tip: Defective steering lock? No big deal - just pry up the cover held by the groove pin carefully with a sturdy screwdriver (or hammer and small chisel)
If the steering lock is engaged, the lock cylinder must be drilled out
For this purpose, first a small drill (3 to 4mm) is set in the middle of the key bit and pre-drilled at low speed
Since the lock is made of brass and only the actual locking bolt is made of steel, it can be rtecht effortlessly rtecht
Then drill the lock deep with an 8 or 9 mm drill and remove completely from the steering tube with the lock cylinder
In any case, the drilled lock should be repealed as a pattern for the replacement lock
Under no circumstances install a lock that is too long, as it may latch into place while driving, blocking the steering
The best way to lubricate the new lock is with graphite or simply with ballitol
The insertion of the new lock - the key is rotated in the closing direction - is done in a few simple steps
To complete the lock repair, the new rivet for the cover plate is retracted